Skip to content

Warranty Information

Wetsuit warranty

Circle One offers a wetsuit warranty on all our flatlock and glued + blindstitched wetsuits for 12 months from date of purchase (always retain your original receipt as proof of date of purchase). This covers damage relating to workmanship and/or materials, and each case will be assessed individually. If the wetsuit falls within the warranty conditions, we will repair, replace or refund it free of charge. Any damage resulting from accident, improper care or negligence, and normal wear and tear of the materials over time, is not covered under warranty. Please refer to our wetsuit care guide for more information on how to care for your wetsuit.

Please note the following warranty exclusions:

  • Damage caused by anything other than defects in materials or workmanship.
  • Use in commercial (including outdoor centre use), rental, teaching or instructional programs or activities.
  • Damage caused by extended or excessive exposure to sunlight, improper handling or storage, or failure to follow the wetsuit care instructions provided with this product.
  • Fitting issues that arise after the wetsuit has been used.
  • Normal wear and tear, including scratches and fading.
  • Wetsuits repaired by another repair service.

Surfboards, skimboards and other items warranty

Surfboards, skimboards, bodyboards, SUPs and accessories are covered for 12 months from the date of original purchase against obvious defects in workmanship and materials. A defect is a fault that comes from how the product was made, rather than from how it has been used, stored or transported, for example a fin box or leash plug that has not been bonded properly.

Delamination is only treated as a manufacturing defect where our assessment shows a clean separation of the laminate from the core, with no blistering, bubbling, impact damage or water damage. Delamination showing any of these signs is not a manufacturing defect.

Each case will be assessed individually by Circle One. We assess the cause of damage from the physical condition of the item, using photos or by inspecting the item itself, and we may ask for it to be returned to us for inspection. We may decline a claim if our assessment shows the damage has been caused by heat, impact, water ingress, improper use, care, storage or accident.

Please note the following are not covered under warranty:

  • Fin damage, and any other impact-related damage (dings, cracks, creases or snapped boards).
  • Pressure dings and foam indentations from normal use.
  • Bubbling, blistering, delamination, yellowing or warping that shows the signs of heat exposure. Heat damage does not require prolonged exposure. It can happen within a short time if a board is left in a car, in a board bag in the sun, in direct sunlight or near a heat source.
  • Fading or discolouration from UV exposure (sunlight).
  • Water damage caused by dings or cracks that have not been repaired promptly.
  • Wear and damage to skimboards from normal use over rocks, shingle or sand.
  • Damage caused by contact with chemicals (chlorine, petrol, solvents etc).
  • Repairs or alterations carried out by anyone other than Circle One or a Circle One authorised dealer.
  • Materials over 1 year old (from date of original purchase).

Looking after your board

A little care goes a long way. Following the guidance below will keep your board in good shape for longer. Damage resulting from not following it is not covered under warranty.

1. Keep it out of the heat and sun

Surfboards and skimboards are sensitive to heat. High temperatures can cause the foam core to expand, leading to bubbling, delamination, yellowing or warping.

  • Never leave your board in a hot car, in direct sunlight, or near a heat source such as a radiator or heater.
  • On the beach, keep it in the shade or under a towel between sessions.
  • A board bag does not protect your board from heat. A bag left in the sun, especially a dark one, can get hotter inside than the board would on its own.
  • Store your board somewhere cool and shaded. A board bag is ideal for storage, as long as the bag itself is kept out of the sun.

Heat damage is not covered under warranty. Bubbling or delamination caused by heat, sun or poor storage is the result of environmental conditions, not a manufacturing fault.

2. Pressure dings and foam indentations

Indentations and pressure dings develop naturally over time, especially where you stand, kneel or paddle. They are normal on all boards and do not affect performance. You can keep them to a minimum by:

  • Paying attention to where you place your feet, knees and chest.
  • Carrying, storing and transporting your board carefully so it does not knock against hard surfaces.
  • Using a padded board bag and soft roof-rack pads when travelling.

Pressure dings from normal use are not a defect and are not covered under warranty.

3. Repair dings and cracks straight away

An unrepaired ding or crack lets water into the core, which can cause permanent damage, soft spots and delamination. Check your board after every session and act quickly:

  • Small dings: dry the area thoroughly, then seal it with a UV-curing resin repair kit as soon as possible.
  • Epoxy / EPS boards: use an epoxy-based repair resin. Polyester resin will melt EPS foam.
  • PU / polyester boards: use a polyester UV-curing resin.
  • Larger damage, cracks or creases: take your board to a professional repairer.
  • Do not use a damaged board until it has been properly repaired.

Water damage from unrepaired dings or cracks is not covered under warranty. Regular checks and prompt repairs are part of owning a board.

4. Skimboard care

Skimboards take more of a beating than most boards. Scuffs, scratches and chips on the bottom and rails from sand, shingle and rocks are normal wear, not a defect.

  • Ride on sand and avoid rocky or shingle areas where you can.
  • Do not throw or drop your board onto hard ground, rocks or concrete.
  • Rinse off sand and salt water after use and let your board dry before storing it.
  • Seal any chips or cracks in the rails or bottom before using the board again, so water cannot get into the core.
  • Follow the heat and storage advice above. Skimboards are just as heat-sensitive as surfboards.

Damage to skimboards from normal use over rocks, shingle or sand is not covered under warranty.

How to make a warranty claim

There is no need to register your warranty with us. Just keep your receipt, or quote your online order number, as proof of date of purchase.

If you bought from an authorised dealer, please contact them in the first instance. For online purchases, contact us directly and include:

  • Your order number or proof of purchase.
  • A short description of the problem.
  • Clear photos of the whole item and close-ups of the affected area.

We will assess your case and get back to you. If we need the item back, please follow our Returns and Exchanges page to return it directly to us.

Call us on +44 (0) 1363 773005 or email us at sales@circle-one.co.uk.

These warranties are in addition to your statutory rights under the Consumer Rights Act 2015 and do not affect them.

Get In Touch

Loading image:
Loading image:

Be Part of a True Surf Legacy

Represent a UK surf brand that’s been shaping surf culture and building surf gear since 1969.

Get Supported as You Progress

We’re passionate about backing up-and-coming groms, stoked surfers, and ocean lovers with the support they need to grow, improve, and chase their goals.

Join a Like-Minded Community

Become part of a close-knit surf community driven by shared stoke, creativity, and a genuine love for life in and around the ocean.

Back to top